The Voice of the Mountain Resort Industry  |  Est. 1962

Advertisement

Creative Designs Leaderboard

May 2011 Issue

The Hidden Cost of Water

With so much attention being paid to energy use, it's easy to overlook the cost of water–and there are many ways to save.

From your first cup of hot coffee in the morning to the last flush of the toilet at night, water is an essential part of our everyday lives, and few people give a thought to what it takes to make that happen. We are surrounded by uses of water that work for us every day, and they all have a cost.

Being in the mountains adds to that cost. If we have facilities higher up on the mountain, we usually have to pump domestic water up to where we need it. The higher you go, the higher the cost. We have a domestic water well located at 8,000 feet and we pump quite a lot of water from there in stages to our Top Gondola Station at just over 11,000 feet.

With many water systems, there is an evolution in their development. At the well at 8,000 feet, for example, we had a 60 hp booster pump that initially needed 60 hp. Over time the system evolved, but we still had a 60 hp pump using 60 hp. We replaced it with a high-efficiency 17 hp pump, and that is now doing the job at a fraction of the operating cost.

It takes vigilance to root out the hidden costs of water. For starters, all mechanical parts of the water system need to be checked at least monthly, and water regulators at least yearly. Water station building envelopes need to be inspected yearly for animal damage, settling, unused pipes, poor insulation, and other degradations, as these can cause heaters to be on more often, or pipes to freeze—driving up the hidden cost of water.

Some remedial steps are very simple. For example, we have a water station that is hard up against a million-gallon tank. I set the inside heater for the station at 40 degrees, as the tank water temp rarely goes below 42 degrees, and it keeps the room well above freezing. If the heater was set to 50 degrees, we would be, in effect, trying to heat the tank water, which would be a huge waste of energy.

A leaking distribution system can raise water usage and increase pumping and/or maintenance costs. We use water from our local water district for a couple of buildings in town and pay $2.07 per 1,000 gallons. If we used that number for the cost of water in the rest of our system, and we had some leaks in the pipes, it would not take long for that wastage to become a sizeable number.

HOSPITALITY AND WATER
Hospitality areas use lots of water, especially hot water. An older guest room showerhead can use up to six gallons of water a minute, and almost all of that is hot water. A low-flow shower head, which flows around two gallons per minute, will use 60 percent less hot water. For guests’ comfort, some manufacturers offer showerheads matched to your water pressure on each floor.

Any reduction in the guest room hot water flow rate will save money. At Mammoth, we use propane and pay as little as $.02 per gallon for hot water. At an average eight minutes per shower, two showers per day per room, with an annual occupancy rate of 70 percent—well, do the math. As an added advantage, during very high occupancy periods, we are less likely to run out of hot water, a very large no-no that can cost you a lot of discounts.

Showers aren’t the only place to cut guests’ water use. Use aerators on room sink faucets so they will use less water. Leaky faucets, especially hot water, should be repaired right away. Low-flow toilets will use less water, too.

Many hospitality operations have a laundry connected with them, and that’s another place for conservation. It is a waste of energy (and money) to use water that’s hotter than needed for the laundry detergent. Other energy-saving steps: use low-temperature detergents and a water softener.

Advertisement

Climb Zip Whip Leaderboard

Then you can get more creative: Preheat the water going to the laundry’s hot water heaters with warm waste water from the washing machines. You can boost the temperature of the incoming water by 20 degrees and reduce the hot water costs by 25 percent.

Even wastewater can have its costs. Some municipal waste water systems measure the outflow on large commercial users and charge by the gallon. The more you produce, the more you pay.

One obvious savings: Waterless urinals. They can save many thousands of gallons of water; at Mammoth we have installed them in many locations. Some designs have cleaning and maintenance issues, but the best units minimize them. Low-flow toilets are also becoming more efficient and maintenance-friendly. Auto faucets and flush devices can also lower the use of water.

SPAS AND POOLS
Some resorts have bigger water issues. For example, pools and spas are generally outside, and a pool/spa is one large heat exchanger. If it is cold outside a lot of heat is released to the air. When not in use, especially at night, put a cover on outside pools to reduce heat loss.

On the other hand, if you have an enclosed pool/spa area, it gets quite humid and warm inside. Typically, resorts use an exhaust system to improve air quality. In that case, use an air-to-air heat exchanger to use heat from the exhausted air to heat the dry incoming air and save a lot of money.

Sign in or enable JavaScript to keep reading.

Advertisement

Prinoth Snow Measurement - Billboard